International Journal of Scientific and Research Publications

IJSRP, Volume 3, Issue 6, June 2013 Edition [ISSN 2250-3153]


Optimization of Process Parameter in Turning of Copper by Combination of Taguchi and Principal Component Analysis Method
      Chintan Kayastha, Jaivesh Gandhi
Abstract: The aim of this article is to optimize the process parameters for turning operation by use of Taguchi and Principal component analysis method. The aim of the present work is to investigate the effects of process parameters on surface finish and material removal rate (MRR) to obtain the optimal setting of these process parameters as product with good finishing surface is desirable in turning process with minimum machining cost.

Reference this Research Paper (copy & paste below code):

Chintan Kayastha, Jaivesh Gandhi (2018); Optimization of Process Parameter in Turning of Copper by Combination of Taguchi and Principal Component Analysis Method; Int J Sci Res Publ 3(6) (ISSN: 2250-3153). http://www.ijsrp.org/research-paper-0613.php?rp=P181265
©️ Copyright 2011-2022 IJSRP - All rights reserved. Use of this web site signifies your agreement to the terms and conditions.